Machining the rotor/cam nut for the screw mechanism:
Turned on a manual lathe to this point, then milled on the 5-axis:
Ohh you will make a custom integrated actuator for this? Exiting! The gif is very satisfying!
Yep, the screw will pass through the center of the motor, and the rotor will be directly mounted to the part in this post.
So advanced! If someone can pull it off, it is you!
This comment has been removed by the author.
Ohh you will make a custom integrated actuator for this? Exiting! The gif is very satisfying!
ReplyDeleteYep, the screw will pass through the center of the motor, and the rotor will be directly mounted to the part in this post.
DeleteSo advanced! If someone can pull it off, it is you!
DeleteThis comment has been removed by the author.
ReplyDelete